WTS-300
Optionally accessories |
|
|
|
Adapter cable USB RS-485
connects the WTS-300 to a PC
- to parameterize the control and to evaluate the data via the free Software Welba-Konsoft Software
- for remote maintenance of the control via permanent connection to a robot-PC (if available).
|
|
|
|
EMAIL, alarm and remote maintenance modem
ESIPM-001
is required for the
- Remote-maintenance via ESIPM-001-modem
- Alarm-message by EMAIL
- Status-request by internet
For the use NO SIM-card is necessary.
|
|
|
|
SMS alarm and remote maintenance modem
ESGSM-001
is required for the
- Remote-maintenance via ESGSM-001-modem
- Alarm-message by SMS
- Status-request by SMS
For the use a standard mobile phone card (SIM-card) with data volume is necessary. |
|
|
|
I/O Expansion module ESIO-001
With I/O expansion modules, WELBA controls can be expanded with additional digital and analog inputs and outputs.
- The 6 output relays can either all be operated with 24VDC or all with 230 V AC.
- The 5 digital inputs (24V DC) can be configured either as NPN or PNP inputs using jumpers. The inputs 1..4 can also measure a frequency of up to 10 kHz.
- The 2 current inputs 4..20 mA with supply voltage connection can be used to connect corresponding sensors.
|
|
|
|
USB-module external ESUSB-1
is used to read out the recorded tank monitor data and fault messages by simply plugging in a standard USB stick.
A PC to retrieve the data is not required.
|
|
|
|
Battery holder (without batterys)
required for the power supply of the control to maintain all tank monitor functions in case of a power failure. |
|
|
Function agitator monitoring module:
The monitoring module is determining the power
input independently for each connected motor and hereof it
will be deduced whether the respective motor rotates and
whether it runs with or without load so that a defective stirring
wing can be detected for example. |
|
Agitator monitoring module ESVAW-001
is installed into the control wire to the agitator motor and
monitors the proper stirring function via the power consumption
of the stirring motor.
- up to 2 agitators
|
|
|
|
Agitator monitoring module ESVAW-002
is installed into the control wire to the agitator motor and
monitors the proper stirring function via the power consumption
of the stirring motor.
- up to 2 agitators including relay
|
|
|
|
Agitator monitoring module ESVAW-003
is installed into the control wire to the agitator motor and
monitors the proper stirring function via the power consumption
of the stirring motor.
- one agitator 3-phase
|
|
|
|
Agitator monitoring module ESVAW-004
is installed into the control wire to the agitator motor and
monitors the proper stirring function via the power consumption
of the stirring motor.
- up to 4 agitators
|
|